PUMP ASSEMBLY

3.01 PUMP

  1. The pump shall be a GunnCo SidesloperTM P3K_____ wide performance pump by GunnCo (contact Mike Gunn @ 770-889-7114) per both the project performance and
    design specifications.

  1. Pump shall be constructed of 316 stainless steel wetted parts including casing, stator housing, impeller, seal and bearing housings, fasteners, seal springs, and discharge fittings. O-Rings shall be Viton material.

  1. Impeller shall be semi-open and capable of passing 1/4" solids, sand, and debris typical of leachate streams.

  1. Pump shall provide a flow of ____ GPM at a discharge pressure of ____’ TDH and ____ GPM @ ____’ TDH.

  1. The motor shall be a 2 Horsepower and shall operate on three-phase [230] [480] volt power, single-phase [230] volt power.

  1. Motor shall have a fixed stator operating on permanently lubricated anti-friction bearings with dual mechanical seals. Seals shall operate in an oil bath and motor shall be air filled type.

  1. Power cable shall be heavy-duty submersible type, continuous length, and sized per U.S. NEC standards. Power cable shall be a minimum of 50' long.

  1. A stainless steel lifting cable shall be provided with each pump. Cable shall be ¼” stainless steel, 7X19 strand construction, rated a minimum breaking strength of 6,400 pounds and shall be equipped with necessary clips with a removable link connector at the pump and a snap hook at the upper end with a properly sized eye bolt to serve as an anchor for the snap hook. Cable length shall be 20’ and shall be adjusted to the required well depth to minimize slack and facilitate lifting.